loadedtea3d
HomeThe Loaded Tea ShopPumpkin Mini
Printed to order

Pumpkin Mini

$23
Body color Orange
Stem color Brown
1

About This Pumpkin

A pumpkin-shaped holder for loaded tea stick packets. Six square slots around the top hold the packets standing up, three to a slot, with the tops showing so you can see each flavor and grab one. The pumpkin turns on its base like our Carousel, and the stem in the center is the knob you turn it by. Lift it off the base to clean. Pick a body color and a stem color. It comes orange with a brown stem, as in the photos, unless you pick other colors. Printed to order in PLA. On a gradient the color bands run up the print.

Getting It

Printed to order. Ready in 3 business days.

Free shipping on orders over $75

  • Ships for $9, free over $75.
  • Free pickup: Within 15 miles, arranged after you order.
  • Local delivery within 15 miles, free.

Holds

18 packets, 3 in each of the 6 slots

What fits

Standard loaded tea stick packs, 35 x 121 mm (about 1 3/8 x 4 3/4 inches)

Size

About 152 mm across and 140 mm tall to the top of the stem (about 6 x 5 1/2 inches)

Looking to buy Loaded Tea?

Stock up on packets for your dispenser at The Loaded Tea Shop.

Affiliate link: we may earn a small commission at no extra cost to you.

Shop Loaded Tea

More The Loaded Tea Shop

Pocket Packet Holder$8Pocket Packet HolderA pocket case for loaded tea stick packets: the Keychain Packet Holder's case without the key loop. The packets stand on end side by side inside, and the whole front is a lid that slides up off the top and clicks shut, so it rides in a pocket, a purse or a glove box and stays closed.Customize
Tilt Dispenser$20Tilt DispenserA tilt-out dispenser for loaded tea packets. One packet shows in the front window, and 13 to 16 more wait in the row behind it, depending on your packet size. Tilt the front open, take one, and it swings back. Pick a housing color and an insert color for each dispenser. Dispensers clip side by side and stack into a bank, and every insert fits every housing, so you can swap them around whenever you like.Customize
Keychain Packet Holder$10Keychain Packet HolderA keychain case for loaded tea stick packets. The packet stands on end inside, and the whole front is a lid that slides up off the top and clicks shut. The loop sits at the top, out of the lid's way, so the case hangs from your keys, bag or lanyard and stays closed.Customize
Top-Grab Bin$18Top-Grab BinAn open-top bin for loaded tea stick packets. The packets stand upright in each slot and you grab one from the top. The front of every slot is cut low between two tabs, so you can see the label on the front packet and pinch it out.Customize

loadedtea3d is an independent maker of 3D printed loaded tea accessories. Not affiliated with any tea brand.