A keychain case made for Kajun Loaded Tea pouches. The pouches lie flat behind the lid and stack front to back, and the whole front is a lid that slides up off the top on rails and clicks shut with two small spring tabs. The loop sits on the top end, flush with the back, so the lid clears it all the way open, and hanging from the loop pulls the lid shut. A finger window in the back pushes the pouches out the front. The Single holds 1 pouch, the Double holds 2 and the Triple holds 3. At about 3 1/2 inches wide it is best as a bag tag on a backpack strap, purse handle or lanyard rather than on a key ring in your pocket. Printed to order in PLA in the color you pick. The key ring is free: pick No ring, a lobster clasp or a cable ring in your color (the photos show a red cable ring).
Printed to order. Ready in 3 business days.
Free shipping on orders over $75
1 pouch (Single), 2 pouches (Double) or 3 pouches (Triple)
Kajun Loaded Tea pouches, about 3 1/8 x 4 7/8 inches (about 80 x 124 mm)
90 x 12 x 143 mm (with the loop)
90 x 19 x 143 mm (with the loop)
90 x 25 x 143 mm (with the loop)
Stock up on packets for your dispenser at The Loaded Tea Shop.
Affiliate link: we may earn a small commission at no extra cost to you.
loadedtea3d is an independent maker of 3D printed loaded tea accessories. Not affiliated with any tea brand.